Metal Spring

Metal Spring
Metal Spring
Price And Quantity
  • 1
  • Unit/Units
    Product Description

    Maxima Springs Manufacturer Compression Springs in Bangalore. Compression Springs are open-coil

    helical springs that offer resistance to a compression force applied axially. Helical compression springs are used to resist applied compression forces or to store energy in a push mode. Compression springs have the most common configuration and are most commonly used in engineering, tools, automotive, aerospace and consumer applications. Most compression springs are straight cylindrical springs made out of round wire.

    Compression Spring Types

    Compression springs from a manufacturer come in a variety of types including

    Conical, Barrel, Hourglass and Cylindrical shapes.

    • Wire Selection round, square or special-section, round being the most adaptable.

    • Compression Spring Mandatory Specification the functional design characteristics.

    • Compression Spring Secondary Specification which is useful for reference and been considered as advisory data.

    • Dimensional Limits governed by the pitch allotted with regard to allowable solid height and outer and inner diameters.

    Stress Level
    determined by the dimensional limits together with the load and deflection requirements. Our compression springs are stress-relieved to remove residual bending stresses produced by the coiling operation.

    Compression Spring Stress Levels

    • A compression spring can be compressed into solid without a permanent set, so that an extra operation for removing the set is not needed. These springs are designed with torsional stress levels when compressed into solid that do not exceed above 40 percent of the minimum tensile strength of the material.

    • A compression spring can be compressed into solid without further permanent set after the set is initially removed. These may be pre-set by the spring manufacturer as an added operation, or they may be pre-set later by the user prior to or during the assembly operation. These are springs designed with torsional stress levels when compressed to solid that do not exceed 60 percent of the minimum tensile strength of the material.

    • Springs, which cannot be compressed into solid without some further permanent set-taking place is because set cannot be completely removed in advance. These springs involve torsional stress levels, which exceed 60 percent of the minimum tensile strength of the material. The spring manufacturer usually advise the user of the maximum allowable spring deflection without set whenever springs are specified in this category.

      RememberIt is extremely important to consider carefully the space allotted to insure that the compression spring would function properly to begin with, thereby avoiding expensive design changes

    Send Your Drawings or Detail Requirement as per below demo Drawing enablingus to send the offer

    Trade Information
    • Paypal, Western Union, Telegraphic Transfer (T/T), Letter of Credit at Sight (Sight L/C), Letter of Credit (L/C), Delivery Point (DP), Days after Acceptance (DA), Cheque, Cash in Advance (CID), Cash Advance (CA), Cash on Delivery (COD), Cash Against Delivery (CAD)
    • Africa, Middle East, Western Europe, Eastern Europe, South America, North America, Central America, Australia, Asia
    • All India
    Contact Us

    35/1, 7th Main, Behind Amba Bhavani Temple Vrushabhavathi Nagar, Near Amba Bhavani Temple, Kamaksipalya Bengaluru Karnataka India +918045803243
    Phone :+918045803243